Push in coupling 3D printer 4mm, M5
Push in coupling 3D printer 6mm, M5
Push in coupling 3D printer 6mm, M6
Nozzle Block 0.5mm right
Nozzle Block 0.5 mm left
Y carriage assembly right (CTR)
Y carriage assembly left (CTR)
Power cord for your Leapfrog Printer, suitable for the US
Timing belt X-axis
Timing belt Y-axis
4 Wire Cable for X (2 connectors) (CRT (XL) / HS (XL) / XD)
Heated Print Bed
Creatr fan set with plug
interchangeable Creatr (XL) Hot End 0.35 mm
The power supply can work both on 115V/230V. Output: 24V 400W.
The Nema 23 stepper motor is used to move the printbed up and down. It has a specially manufactured 6mm axis.
The Nema 17 stepper motor is used for the extruders and both the Y- and X-axis.
Filament guiding tube 6mm-4mm
The induction sensor is used to indicate the home position of the bed on the Z-axis.
Leapfrog Electronics Board
The micro switch is a mechanical switch. These are used to indicate the home position of the both the X- and Y-axis.
Nozzle Block 0.35mm left
Nozzle Block 0.35mm right
Linear bearing used on the X-axis. Inner diameter 8mm.