Push in coupling 3D printer 4mm, M5
Push in coupling 3D printer 6mm, M5
Push in coupling 3D printer 6mm, M6
Nozzle Block 0.5mm right
Nozzle Block 0.5 mm left
Power cord for your Leapfrog Printer, suitable for the United States
Timing belt X-axis
Timing belt Y-axis
Fan Duct (HS / HS XL)
A20 processor board
Creatr Heated Print Bed
Drive unit (HS)
Drive unit cooler (HS) (set of 2)
The Nema 17 stepper motor is used for the extruders and both the Y- and X-axis.
Filament guiding tube 4mm-2mm
Filament guiding tube 6mm-4mm
Heater cartridge assembly (HS)
HS fan with plug
The induction sensor is used to indicate the home position of the bed on the Z-axis.
The micro switch is a mechanical switch. These are used to indicate the home position of the both the X- and Y-axis.
Nozzle Block 0.35mm left
Nozzle Block 0.35mm right
Radial fan 50x50x15 24V assembly (HS)