Push in coupling 3D printer 4mm, M5
Push in coupling 3D printer 6mm, M5
4 Wire Cable for X (2 connectors) (CRT (XL) / HS (XL) / XD)
Push in coupling 3D printer 6mm, M6
Nozzle Block 0.5mm right
Nozzle Block 0.5 mm left
Power cord for your Leapfrog Printer, suitable for the US
Timing belt X-axis
Timing belt Y-axis
Fan Duct (HS / HS XL)
A20 processor board
Heated Print Bed
The Nema 23 stepper motor is used to move the printbed up and down. It has a specially manufactured 6mm axis.
Drive unit (HS)
Drive unit cooler (HS) (set of 2)
The Nema 17 stepper motor is used for the extruders and both the Y- and X-axis.
Filament guiding tube 4mm-2mm
Filament guiding tube 6mm-4mm
Heater cartridge assembly (HS)
HS fan with plug
The induction sensor is used to indicate the home position of the bed on the Z-axis.
The micro switch is a mechanical switch. These are used to indicate the home position of the both the X- and Y-axis.
Nozzle Block 0.35mm left
Nozzle Block 0.35mm right
Radial fan 50x50x15 assembly (HS)
Linear bearing used on the X-axis. Inner diameter 8mm.