Creatr HS XL
Push in coupling 3D printer 4mm, M5
Push in coupling 3D printer 6mm, M5
Push in coupling 3D printer 6mm, M6
Nozzle Block 0.5mm right
Nozzle Block 0.5 mm left
Micro switch (XL / HS XL)
Power cord for your Leapfrog Printer, suitable for the US
Timing belt X-axis
Timing belt Y-axis
Fan Duct (HS / HS XL)
A20 processor board
4 Wire Cable for X (2 connectors) (CRT (XL) / HS (XL) / XD)
The induction sensor is used to indicate the home position of the bed on the Z-axis.
The Nema 23 stepper motor is used to move the printbed up and down. It has a specially manufactured 6mm axis.
Drive unit (HS)
Drive unit cooler (HS) (set of 2)
The Nema 17 stepper motor is used for the extruders and both the Y- and X-axis.
Filament guiding tube 4mm-2mm
Filament guiding tube 6mm-4mm
Heated Print Bed
Heater cartridge assembly (HS)
HS fan with plug
Nozzle Block 0.35mm left
Nozzle Block 0.35mm right
Radial fan 50x50x15 assembly (HS)
Linear bearing used on the X-axis. Inner diameter 8mm.