Push in coupling 3D printer 6mm, M6
Nozzle Block 0.5 mm left
Micro switch (XL / HS XL)
Power cord for your Leapfrog Printer, suitable for the US
Timing belt X-axis
Timing belt Y-axis
4 Wire Cable for X (2 connectors) (CRT (XL) / HS (XL) / XD)
Heated Print Bed
The induction sensor is used to indicate the home position of the bed on the Z-axis.
Creatr fan set with plug
Nozzle Block 0.5mm right
Creatr (XL) Hot End 0.35 mm
The power supply can work both on 115V/230V. Output: 24V 400W.
The Nema 23 stepper motor is used to move the printbed up and down. It has a specially manufactured 6mm axis.
The Nema 17 stepper motor is used for the extruders and both the Y- and X-axis.
Filament guiding tube 6mm-4mm
Leapfrog Electronics Board
Nozzle Block 0.35mm left
Nozzle Block 0.35mm right
Linear bearing used on the X-axis. Inner diameter 8mm.